Stealth Labs Tech Support
How to avoid problems in your next StealthFlex installation
We have a page showing an example of what not to do when installing a StealthFlex system.  This site had an old dilapidated fence with lots of brush and vines touching the fabric in sev...
09-18-2008
Can the GSM-900 be used as the primary communicator (no phone line)?
Q:  Can we use the GSM-900 in an installation that has no telephone line?

A:  Absolutely!  Connect the control panel's dialer terminals or RJ jack to the GSM-900 Interface Module as shown in the installation manual.  Then simply don't con...
08-25-2008
Stealth Labs Introduces the GSM-900 Low-Cost Contact ID Cellular Backup System
You spoke - we listened.  You asked for a cost-reduced cellular backup system.  We took everything good about the GSM-1650 and removed everything else.  We took the most popular dialer format, Contact ID, and optimized the GSM-900 specifically for that...
08-12-2008
ILF-100 FAQ
This FAQ was included in the original ILF-100 manual, but later removed to reduce the size of the document.  We are posting it here because it contains some very useful information:

FAQ

Q:...
07-09-2008
Is there a way to make the TM-66 delay for 2 or more hours?
No.  It sounds like you need the TM-67 timer module.  The TM-67 has 3 timing modes:  Seconds, Minutes, and Hours.  It is actually a TM-66 board with different firmware.

Click here to view the TM-67 Instru...
06-17-2008